Intermec CK32IS Manual do Utilizador descarregar pdf (Página 118)

Chapter 4— Developing and Installing Applications

102 CK32 I-Safe Handheld Computer Users Manual

AutoCab Script Commands

Example:

; Install all cab files in the \Flash File Store\XYZ directory,

regardless.

AutoCab -FILE="\Flash File Store\XYZ\.cab" -FORCE

; Install only one cab file, use Intermec cab installation display

AutoCab -FILE=”\myCab\app.cab” =show=2

Command Description

-ChkRst= Set to 1 to configure AutoCab to check for the

Reset flag after all .cab files are installed. This file is

created by .cab files that want a clean reset after

installation. Default is 0 (do not check for flag).

-File= Specifies the .cab files to extract. Note that the

specified files need not end with the .cab extension.

-Force Forces the specified .cab files to extract regardless of

whether it was previously extracted.

-Log= Set to 1 to create a log file in the same folder that

AutoCab is running. Useful for debugging .cab

installation. Default is 0 (disabled).

-Move= Set to 1 to force source .cab file deletion, even

when read-only bit set on file. Default is 0

(disabled).

-Quiet= Set to 0 to allow AutoCab to display user message

box on errors. Useful for debugging .cab

installation. Default is 1 (keep quiet).

-Show= Set to 0 to prevent showing any installation

progress interfaces and also prevents canceling the

installation. Set to 1 to show normal installation.

Set to 2 to show Intermec installation progress

interface (user can see what is installing but cannot

cancel it). Default is 1 (show normal).

-Signal= Set to string name of signal to use at the

completion of .cab installation before a reboot

occurs (if enabled). AutoCab uses

WaitForSingleObject on this name. Default is

disabled.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 148 149

Sem comentários

Intermec CK32IS Manual do Utilizador Página 118