Intermec PM43c Manual do Utilizador descarregar pdf (Página 102)

Chapter 6 — Maintain the Printer

90 PM43 and PM43c Mid-Range Printer User Manual

Clean the Media Guides

Both the upper and lower media guides are transparent to allow light

to pass between the two parts of the label gap and label mark sensors.

It is important to keep these surfaces free of dust, stuck labels, and

adhesive residue.

1 Turn the printer off and disconnect the printer from power.

2 Open the media cover.

3 Remove the media and ribbon (if installed).

4 Insert a cleaning card or a soft cloth soaked in isopropyl alcohol

between the two media guides to clean them.

5 Wait for approximately 30 seconds to allow the cleaning fluid to

dissolve the residue.

6 Once the parts are dry, replace the media (and ribbon) in the

printer.

7 Close the media cover, reconnect power, and turn on the printer.

Clean the Exterior of the Printer

Make sure to keep the exterior of the printer clean. Maintaining a clean

exterior will reduce the risk of dust or foreign particles reaching the

inside of the printer and affecting printer functionality.

Use a soft cloth, possibly moistened with water or a mild detergent,

when cleaning the printer exterior.

Make sure to keep the surface surrounding the printer clean as well.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 149 150

Sem comentários

Intermec PM43c Manual do Utilizador Página 102