Intermec CK60 Manual do Utilizador descarregar pdf (Página 52)

Chapter 3 — Configuring the Computer

38 CK60 Mobile Computer with Windows CE User’s Manual

For the CK60, .cab files register DLLs, create shortcuts, modify registry

entries, and run custom setup programs. Tap a .cab file to extract that file

or place the .cab file on one of the approved storage devices in the

“\CabFiles” folder, then perform a warm-boot on the CK60. There are two

methods available to extract a .cab file:

• Tap a .cab file to extract it. With this method, the .cab file is

automatically deleted when the extraction process is successful, unless the

.cab file is set with the read-only attribute.

• Use the AutoCab method to extract all files when a cold-boot is

performed on the CK60. This method is available in the Software Tools

User’s Manual via the IDL, which is downloadable from the Intermec

web site at www.intermec.com/idl. Contact your Intermec

representative for information.

Installing Applications on the Computer

Consider any of these options to get the package to the preferred location

on your CK60:

• Microsoft ActiveSync (below)

• Secure Digital storage cards (page 39)

• SmartSystems™ Console (page 40)

Using Microsoft ActiveSync

You can use Microsoft ActiveSync to establish a connection between your

PC and the CK60. Microsoft ActiveSync transfers files, synchronizes files,

performs remote debugging, and other device management activities.

See Chapter 2 “Windows CE” for information about the Microsoft

ActiveSync application as provided by Microsoft Corporation.

This can be a serial, a USB, or an 802.11b/g Microsoft ActiveSync

connection. Files can be copied using Windows Explorer on a PC or a

laptop computer. This is usually good when updating a few CK60s.

These instructions assume that Microsoft ActiveSync was installed onto

your PC and is up and running. If not, go to Chapter 2 “Windows CE”

for an URL from which to download the latest application.

1 Connect the CK60 to a PC using a USB or serial cable. You may have to

detach, then reattach the cable to “wake” the connection.

2 Wait for a “Connected” message to appear in the Microsoft ActiveSync

application to signal a connection to the CK60. If necessary, select File >

Get Connected to initiate a connection or detach, then reattach the USB

or serial cable.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 123 124

Sem comentários

Intermec CK60 Manual do Utilizador Página 52