Intermec CK31 Manual do Utilizador descarregar pdf (Página 140)

Chapter 5 — Troubleshooting and Maintaining the CK31

CK31 Handheld Computer User’s Manual 123

Problems While Scanning Bar Codes (continued)

Problem Solution

Your 1551E or 1553 scanner

stopped working after you activated

energy saver mode or connected a

cable.

You can enable energy saver mode only if the

scanner is connected to the CK31 by the energy

saver cable P/N 3-606032-03. Follow these steps:

1 Disconnect the scanner from the CK31.

2 Find the Reset Factory Defaults bar code in the

scanner documentation.

3 While pulling the trigger, hold the scanner over

the Reset Factory Defaults bar code, and apply

external power to the scanner. The scanner is

reset to factory defaults.

4 Use Intermec Settings to disable energy saver

mode on the CK31.

5 Use Intermec Settings to disable the port.

6 Attach the scanner to the CK31.

7 Use Intermec Settings to enable the port.

8 Use the scanner to scan a bar code. The scanner

should work now, but energy saver mode is

disabled. Continue with Steps 9 through 11

only if you want to use energy saver mode.

9 Install the P/N 3-606032-03 energy saver cable.

10 Use Intermec Settings to enable energy saver

mode on the CK31.

11 Use the scanner to scan a bar code. Energy saver

mode is enabled.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 207 208

Sem comentários

Intermec CK31 Manual do Utilizador Página 140