Intermec CK70 Manual do Utilizador descarregar pdf (Página 100)

Chapter 6 — Configure the Computer

86 70 Series Mobile Computer User Manual

About Network Communications

You can easily add the mobile computer to your wireless or wired data

collection network. You can connect your computer using:

• 802.11a/b/g/n radio communications.

• Ethernet communications.

• Bluetooth communications.

• USB and serial communications.

Configure 802.11a/b/g/n (Wi-Fi) Radio Communications

The mobile computer contains an 802.11 radio to transfer data using

wireless communications and to support the TCP/IP network

protocols. This section of the manual assumes that your wireless

network is set up, including your access points.

By default, the 802.11 radio is disabled. Use the following procedure to

enable the Wi-Fi radio using Intermec Settings. If you would like to use

ScanNGo bar codes to easily enable the radio and set the default

security settings, see Appendix C, “ScanNGo Wi-Fi Configuration

Bar Codes” on page 187.

1 Tap Start > Settings > System > Intermec Settings.

2 From the Intermec Settings main menu, tap Communications >

802.11 Radio > Radio Enabled.

3 Select the Radio Enabled check box and tap OK. By default, the

computer uses Funk security and enables DHCP.

4 Use Intermec Settings to configure any other parameters you need

to use for communication with your network.

5 Configure 802.11 security. For help, see “About Wireless

Security” on page 95.

Configure Ethernet Communications

To configure Ethernet communications, connect your mobile

computer to your Ethernet network using the Ethernet Snap-On

Adapter (Model 1000AA01) or an Ethernet dock.

1 Connect the Ethernet snap-on adapter to your mobile computer.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 217 218

Sem comentários

Intermec CK70 Manual do Utilizador Página 100