Intermec CK70 Manual do Utilizador descarregar pdf (Página 142)

Chapter 8 — Troubleshoot and Maintain the Computer

128 70 Series Mobile Computer User Manual

Reset the Computer

If the computer does not resume after pressing the Power button, or if

the computer or an application locks up, you may need to reset the

computer. The computer uses the configuration currently saved in

flash memory during the boot process. There are three ways to reset the

computer:

• Reboot

• Cold boot

• Clean boot

Reboot the Computer

You may need to reboot the computer to correct conditions where an

application stops responding to the system.

To reboot the computer, press the Power button and select Reboot

from the menu. The computer systematically shuts down, restarts, and

goes through the initialization process.

Cold Boot the Computer

In some cases where the computer completely stops responding, it may

be necessary to perform a cold boot or hard reset. Because cold booting

may result in data loss, use this method only if all other recovery

methods have failed.

1 Press the Power button to suspend the computer.

2 Remove the handstrap and the battery pack.

3 Press the Reset button in the battery compartment on the back of

the computer.

Note: Cold booting the computer does not guarantee that cached disk

data will be saved, so transactional data may be lost during the reset.

All other data, such as configuration and network settings, is

preserved.

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 217 218

Sem comentários

Intermec CK70 Manual do Utilizador Página 142