Intermec CK31 Manual do Utilizador descarregar pdf (Página 43)

Chapter 1 — Using the CK31 Handheld Computer

26 CK31 Handheld Computer User’s Manual

Scanning With the Standard or Near-Far Range Area Imager

Your CK31 may come with one of two types of area imagers:

• A standard area imager

• A near-far range area imager

Both area imagers allow you to scan 2D bar code symbologies

and supports omni-directional (360°) scanning. Omni-

directional scanning means that you can position the CK31 in

any orientation to scan a bar code label.

Scanning with the Standard Area Imager

The standard area imager comes equipped with an aiming beam

to help you scan bar codes. Use the following procedure to scan

a bar code label with the standard area imager.

To scan a bar code label with the area imager

1 Press I to turn on the CK31.

2 Point the scanner window at the bar code label and hold the

CK31 steady a few inches from the label.

3 Press the Scan button on the keypad or pull the trigger on a

handle and center the red aiming beam over the bar code

label, as shown in the illustration on the next page.

The aiming beam flashes repeatedly while the imager tries to

read a bar code. Also, the aiming beam is smaller when the

imager is closer to the bar code and larger when it is further

away.

When the CK31 successfully reads a bar code label, you hear

a high beep and the green Good Read light turns on briefly.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 207 208

Sem comentários

Intermec CK31 Manual do Utilizador Página 43